 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| 155 Mbps Single Mode Transceiver C-13-155-T3-SST3A-14-G5 Features * Duplex ST Single Mode Transceiver * Industry Standard 1x9 Footprint * Intermediate Reach SONET OC-3 SDH STM-1 Compliant * Single +3.3V Power Supply * PECL/LVPECL Differential Inputs and Outputs * Wave Solderable and Aqueous Washable * LED Multisourced 1x9 Transceiver Interchangeable * Class 1 Laser Int. Safety Standard IEC 825 Compliant * Uncooled Laser Diode with MQW Structure * Complies with Telcordia (Bellcore) GR-468-CORE * Temperature Range: -40 to 85C * SD PECL/LVPECL level * ATM 155 Mbps Links Application * SONET/SDH Equipment Interconnect Application * Receiver squelch function * RoHS compliance available Absolute Maximum Rating Parameter Power Supply Voltage Output Current Soldering Temperature Storage Temperature Symbol Vcc Iout Tstg Min. 0 0 -40 Max. 3.6 30 260 85 Unit V mA C C 10 seconds on leads only Note Recommended Operating Condition Parameter Power Supply Voltage1 Operating Data Rate Note 1 : Please refer to ordering information Temperature1 (Case) Symbol Vcc Topr Min. 3.1 -40 Typ. 3.3 155 Max. 3.5 85 Unit V C Mbps Transmitter Specifications, Parameter Optical Optical Transmit Power Output Center Wavelength Output Spectrum Width Extinction Ratio Output Pulse Mask Output Eye Optical Rise Time Optical Fall Time Relative Intensity Noise Total Jitter tr tf RIN TJt Po ER -15 1261 8.2 1310 -8 1360 7.7 dBm nm nm dB RMS() output power is coupled into a 9/125 m single mode fiber Symbol Min Typical Max Unit Notes Compliant with FDDI SMF-PMD1 Compliant with Bellcore TR-NWT-000253 and ITU-T recommendation G.957 2 2 -116 1.2 ns ns dB/Hz ns Measured with 223-1 PRBS with 72 ones and 72 zeros. 10% to 90% Values 10% to 90% Values www.municom.de 1 LUMNDS1914-Aug1208 Rev. A.1 155 Mbps Single Mode Transceiver C-13-155-T3-SST3A-14-G5 Transmitter Specifications, Parameter Electrical Power Supply Current Data Input Current-Low Data Input Current-High Differential Input Voltage Data Input Voltage-Low Data Input Voltage-High ICC IIL IIH VIH-VIL VIL-VCC VIH-VCC -350 300 -2.0 -1.1 160 350 -1.58 -0.74 mA A A mV V V These inputs are compatible with 10K, 10KH and 100K ECL and PECL inputs Maximum current is specified at Vcc= Maximum @ maximum temperature Symbol Min Typical Max Unit Notes Receiver Specifications, Parameter Optical Sensitivity Maximum Input Power Signal Detect-Asserted Signal Detect-Deasserted Signal Detect-Hysteresis Wavelength of Operation Pin Pa Pd -7 -47 1.0 1100 -34 -34 4.0 1600 dBm dBm dBm dBm dB nm Measured on transition: low to high Measured on transition: high to low measured with 223-1 PRBS with 72 ones and 72 zeros. Symbol Min Typical Max Unit Notes Receiver Specifications, Parameter Electrical Power Supply Current Data Output Voltage-Low Data Output Voltage-High Signal Detect Output Voltage-Low Signal Detect Output Voltage-High ICC VOL -Vcc VOH- Vcc VSDL-Vcc VSDH- Vcc -2 -1.1 -2 -1.1 100 -1.58 -0.74 -1.58 -0.74 mA V V V V The current excludes the output load current These outputs are compatible with 10K, 10KH and 100KECL and PECL outputs. C-13-155-T3-SST3A-14-G5 Symbol Min Typical Max Unit Notes www.municom.de 2 LUMNDS1914-Aug1208 Rev. A.1 155 Mbps Single Mode Transceiver C-13-155-T3-SST3A-14-G5 Connection Diagram 1. (Rx GND) 2. (RD +) 3. (RD-) 4. (SD) 5. (Rx Vcc) 6. (Tx Vcc) 7. (TD-) 8. (TD+) 9. (Tx GND) NC Top View NC Receiver Signal Ground Receiver Data Out Receiver Data Out Bar Signal Detect Receiver Power Supply Transmitter Power Supply Transmitter Data In Bar Transmitter Data in Transmitter Signal Ground PIN 1 2 3 4 5 6 7 8 Warnings 9 Legal Notice Symbol RxGND RD+ RDSD RxVcc TxVcc TDTD+ TxGND Notes Directly connect this pin to the receiver ground plane See recommended circuit schematic See recommended circuit schematic Active high on this indicates a received optical signal DC power for the receiver section DC power for the transmitter section See recommended circuit schematic See recommended circuit schematic Directly connect this pin to the transmitter ground plane www.municom.de 3 LUMNDS1914-Aug1208 Rev. A.1 155 Mbps Single Mode Transceiver C-13-155-T3-SST3A-14-G5 Recommended Circuit Schematic C-13-155-T3-SST3A-14-G5 Tx Vcc C5 Rx Vcc 98 R1 R3 765 432 1 R9 R5 R7 C6 TD + TD - RD + RD - Tx Vcc Rx Vcc R2 R4 SD R10 R6 No internal connection Transceiver Top view No internal connection R8 L1 Vcc Notes +3.3V: R1=R3=R5=R7=R9=130 R2=R4=R6=R8=R10=82 C1=C2=C3=C5=C6=0.1F C4=10F L1=L2=1H C3 C1 Rx Vcc L2 C4 C2 Tx Vcc The split-loaded terminations for ECL signals need to be located at the input of devices receiving those ECL signals. The power supply filtering is required for good EMI performance. Use short tracks from the inductor L1/L2 to the module Rx Vcc. A GND plane under the module is required for good EMI and sensitivity performance. Label Model Number: C-13-155-T3-SST3A-14-G5 www.municom.de 4 LUMNDS1914-Aug1208 Rev. A.1 155 Mbps Single Mode Transceiver C-13-155-T3-SST3A-14-G5 Package Diagram C-13-155-T3-SST3A-14-G5 y Top View Front View Units: mm Side View Rear View www.municom.de 5 LUMNDS1914-Aug1208 Rev. A.1 155 Mbps Single Mode Transceiver C-13-155-T3-SST3A-14-G5 Ordering Information Available Options: C-13-155-T3-SST3A-14-G5 Part numbering Definition: C - 13 - 155 - T3 - S ST Tx Power Temperature and Package -14 -RoHS * Wavelength 13 = 1310 nm * Communication protocol (155Mbps) 155 = PECL Signal Detection Optupt * T3 = +3.3V Transceiver, FP * Single mode fiber * Connector options (ST) * TxPower 3 = -15 to -8 dBm * Temperature and Package A = Commercial temperature (-40 to 85 ) * -14 :Municom customization label, squelch function, ST housing is isolated from the PCB ground * RoHS compliance available G5 = RoHS 5/6-compliant product (lead exemption) www.municom.de 6 LUMNDS1914-Aug1208 Rev. A.1 155 Mbps Single Mode Transceiver C-13-155-T3-SST3A-14-G5 Qualification Information The 155 Mbps SM Transceiver has passed the following qualification tests and meets the intent of Telcordia (Bellcore) GR-468-CORE. Qualification Test Mechanical Shock Vibration Solderability Thermal Shock Temperature Cycling Damp Heat Cyclic Moisture Resistance ESD Condition 500 g 20g, 20 Hz-2,000 Hz 25C 500 cycles 40C, 95% RH, 1344 hrs 10 cycles 500V Sample Size 11 11 11 11 11 11 11 6 Reference MIL-STD-883 MIL-STD-883D Method 2007 MIL-STD-883E Method 2003.7 MIL-STD-883 Method 1011 MIL-STD-883 Method 1010 MIL-STD-202 Method 103 MIL-STD-883 Method 1004 MIL-STD-883D Method 3015.7 Warnings: Handling Precautions: This device is susceptible to damage as a result of electrostatic discharge (ESD). A static free environment is highly recommended. Follow guidelines according to proper ESD procedures. Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indirect radiation. Legal Notes: IMPORTANT NOTICE! All information contained in this document is subject to change without notice, at Municom's sole and absolute discretion. Municom warrants performance of its products to current specifications only in accordance with the company's standard one-year warranty; however, specifications designated as "preliminary" are given to describe components only, and Municom expressly disclaims any and all warranties for said products, including express, implied, and statutory warranties, warranties of merchantability, fitness for a particular purpose, and non-infringement of proprietary rights. Please refer to the company's Terms and Conditions of Sale for further warranty information. Municom assumes no liability for applications assistance, customer product design, software performance, or infringement of patents, services, or intellectual property described herein. No license, either express or implied, is granted under any patent right, copyright, or intellectual property right, and Municom makes no representations or warranties that the product(s) described herein are free from patent, copyright, or intellectual property rights. Products described in this document are NOT intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. Municom customers using or selling products for use in such applications do so at their own risk and agree to fully defend and indemnify Municom for any damages resulting from such use or sale. THE INFORMATION CONTAINED IN THIS DOCUMENT IS PROVIDED ON AN "AS IS" BASIS. Customer agrees that Municom is not liable for any actual, consequential, exemplary, or other damages arising directly or indirectly from any use of the information contained in this document. Customer must contact Municom to obtain the latest version of this publication to verify, before placing any order, that the information contained herein is current. All rights reserved www.municom.de 7 LUMNDS1914-Aug1208 Rev. A.1 |
Price & Availability of C-13-155-T3-SST3A-14-G5
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |